在設備實際操作運行過程中，自動混凝土攪拌機的變速器是一個非常重要的部件。因此，我們在使用過程中對其油質需要有一定的檢測工作，那么我們具體應該怎么進行操作呢？

During the actual operation of the equipment, the transmission of the automatic concrete mixer is a very important component. Therefore, we need to have some inspection work on the oil quality during the use, so how should we operate?

1、將自動混凝土攪拌機停放在水平地面上，并拉緊手制動。

1. Park the automatic concrete mixer on the level ground and tighten the hand brake.

2、讓發動機怠速運轉數分鐘。

2. Allow the engine to idle for a few minutes.

3、踩住制動踏板，將操縱手柄撥至倒擋、前進擋等位置，并在每個擋位上停留幾秒鐘，使液力變矩器和所有換擋執行元件中都充滿液壓油。后將操縱手柄撥至停車擋位置。

3. Step on the brake pedal, move the joystick to reverse gear, forward gear, etc., and stay in each gear for a few seconds to make the hydraulic torque converter and all shift actuating elements full of hydraulic oil. Then, turn the joystick to the parking position.

4、從加油管內撥出自動變速器油尺，將擦干凈的油尺全部插入加油管再拔出，檢查油尺上的油面高度。

4. Pull out the automatic transmission oil dipstick from the oil filler pipe, insert the cleaned oil dipstick into the oil filler pipe and then pull it out, and check the oil level on the oil dipstick.

在對自動混凝土攪拌機變速器進行檢查或故障診斷前，先要對變速器油面和油質進行檢查。把選擋手柄放在P位，將發動機在怠速時至少運轉數分鐘，油液達到正常工作溫度，汽車須停放在水平路面上，這樣才能確保在差速器和變速器之間的油面高度正常、穩定。

Before checking or diagnosing the transmission of the automatic concrete mixer, check the oil level and quality of the transmission. Put the gear selection handle at P position, and run the engine at idle speed for at least a few minutes. The oil reaches normal operating temperature. The car must be parked on a level road, so as to ensure that the oil level between the differential and the transmission is normal and stable.

自動混凝土攪拌機變速器油質的檢測方式就講解到這里了，可供您參考使用，要結合您的實際情況來使用方法，更多相關內容的了解就來我們網站http://www.wxthfs.com看看吧！

The inspection method of the transmission oil quality of the automatic concrete mixer is explained here for your reference. You should use the method according to your actual situation. For more information, please come to our website http://www.wxthfs.com Look!